Tag: Star Wars

With everything complete, it is time to start final assembly of my lightsaber.

Here I am going to finish fabricating some of the final pieces, then get everything assembled for a test fit.

It this part I am going to focus on the fabrication of all the metal chassis disk components to replace all the temporary laser cut acrylic and 3D

With all the planning complete, it is time to start on initial part fabrication and a test assembly of the chassis.

Here, I am going to go over the two remaining sub-assemblies. The crystal chamber and the electronics assembly.

For this project I am going to attempt to make a replica of the Skywalker Lightsaber.

This is it, the fifth and final part of my Mandalorian Helmet build. In this post I will cover the weathering process and the addition of the black

I am going to go over each step of the process I used to make my Mandalorian Helmet silver and explain what I did, what I could have

It’s time to move onto priming, and cleaning up this helmet to get it ready for paint.

With all the printing finished it is time to start cleaning up the parts and sanding away those layer lines so I can get everything assembled.